I feel like I must be staring right at it, but I’m not finding any existing posts that answer my question.
My bar numbers are a certain distance from the staff. My multi measure rest number ranges are a different distance from the staff. Clearly there’s a separate parameter for each. I’m finding stuff for location (above/below), but where do I set the distances so I can make these the same?
You can change the default position below the staff of multi-bar rests by going to:
Engraving Options > Rests > Multi-bar Rests > Design > Bar number range distance below staff (Number 6)
However, this is a project-wide setting. I’d advise using the figure that is the same as the most number of Layouts… if that makes sense…
It’s relatively easy to Cmd+click a heap of the bar number ranges in Engrave mode but I understand that this may be tedious if there is a lot of Layouts that won’t be using your settings.
Perfect, thank you! I knew it had to be staring me in the face, but my eyes were just missing it. Exactly the solution here!