Hello all,
can someone help me. I want to automate a controller curve of a plugin. At the moment I can only do it with the draw function. Unfortunately, this is much too inaccurate. Therefore, I would like to enter a starting value and a closing value. Unfortunately, this does not succeed…Does anyone have an idea?
Hi and welcome to the forum,
Do I understand you right, you want to make a straight line from node A to node B? Then delete all nodes inside and you are done. If you want to set the exact value of Node A, select it and type the value in the Info View.
Thanks for your information.
I tried that several times, but it never worked. However, I have now figured it out. The value of the entry was not taken over, because I was in the touch mode. Now I switched to cross over mode and it works. Thanks for your tip.