I have a midi logical editor that I use all the time for quick mixing. Basically it transforms my current CC7 (volume) automation by adding 5 to all CC7 in the selected region. (I have another for minus 5). I’ve assigned these to key commands and I can quickly change the volumes of my midi instruments!
I’m wondering if the same thing can be done with track automation for audio tracks? Trying to get the project logical editor to do it but I’m stumped. The main thing is I need a way to automatically place automation nodes at cycle boundaries, but I cannot figure out how to do this. Is it possible?
Here was my thoughts
- Transport - Locators to Selection
- *Add automation nodes at locators (dont know how to do this part)
- Project logical editor - Position inside cycle -> Action = Trim Multiply by 1.0200
I would probably combine all 3 in to a macro as long as #2 only creates the nodes once. That is assuming it possible at all. My goal here is to use this on audio tracks that A) have insert FX processing on them that I do not want to alter (so I cannot use clip gain as its pre FX) or B) have automation ramps / curves that I want to make louder or softer.