Setting Up WaveLab Pro 9.5

How do you set up WL Pro 9.5 to record on two channels? Also, why is Wavelab Pro 9.5 recording with poping sounds and what do I need to do to stop the poping sounds. I’m using an iMac with a Audiobox USB interface.

Please help!!!


check here

In the recording dialog select stereo for 2 channels and set in Audio Device/Control Panel
Buffert size to 256 or 512 Samples and select like .wav and bit depth to 16-24 as recording format.

regards S-EH

Thanks S-EHansson. That worked! However, I still can’t record on two channels. It shows two channels but only record in Channel 1. Any suggestions?

Thank you

Try this first:

even check with Built-in Audio in OSX to set up and try…
then switch over to your other Audio Device it should be the
same setup, even check if there is a control panel/setup panel
for your Audio Device for Mono, Stereo etc

regards S-EH