Is there a setting to manage the minimum spacing gap around a mid-bar clef change? In tight spacing situations it would help a lot.
In Engraving Options > Spacing Gaps, I have not found anything specifically about this.
Thanks
Is there a setting to manage the minimum spacing gap around a mid-bar clef change? In tight spacing situations it would help a lot.
I see …
Given the specificity of the wording in other lines of the dialogue where “mid-system” is mentioned, and also looking at the image depicting a clef change before a barline, I didn’t think that would have made any effect.
Now that I think of it, the lack of specificity in this case should’ve been interpreted as an “any clef change”.
Thank you.