Strip knobs not displayed if using Novation Automap

Hi, I want to report this misbehaviour I found using Cubase 7.0.2 (running at 64 bits on OSX 10.8.2) with Novation Automap 4.5.0.

If, in the VST3 section of Automap software setup, I enable the wrapping of “Cubase Plug-in Set”, then the strip knobs are not displayed. They display correctely as long as I disable the wrapping (but obviously I can’t control Cubase’s fx using my Nocturn anymore, unless I use it as a normal midi controller with the Generic Remote or I map the fx on the new Remote Control Editor).

I’m going to report the issue also to Novation.

Hi Sin Night,

Thanks for your thread.

Has your issue been fixed in the meantime?

Do you have a case number?

Please let me know, if I can be of any further assistance to you.

With best regards,

Marcel // Novation Technical Support

Hi, Thank You very much for your care!

I reported the issue to your technical support (I have a case number), I’ve been confirmed of the problem and I’ve been told that it will be fixed in a future version of Automap.
As today the issue is not fixed yet, but I’m cool with it as I can imagine this bug requires a good amount of new code in order to handle these new features of Cubase. :wink:

Best Regards,

It’s Ok here

Hi Antonio,

Thanks for your reply.

You may want to pass me on your case number.

With best regards,

Marcel // Focusrite Novation Support