Supervision vst Vs on board LU Meter


Supervision has lots of nice options ! exciting to use. But i’m not sure i’m using it right.
I put it on my master out. It’s convenient when i want to listen to the master or if i want to analyse a single track i put it solo and i read the Supervision on the master.
But when i activate say my M&E monitor source then what i read on the supervision is still the master not the actual M&E i selected where the onboard Loudness meter on right tab of nuendo follows the monitor source.
is there a way to set supervision so it follows monitor selection ?

You should really read the manual… really…
You have plugin slots all over…
8 per monitor destination (Speakers)
8 per monitor bus
8 per headphone bus

just to name the obvious