which I don’t want either.
Of course I can manually adjust the slur on the 1st page, but then the 2nd part of the slur (after the page break) still remains there and cannot made invisible (this would also hide the 1st part of the slur).
The following “solution” was created by moving the 2nd part of the tie off the printing area, which is of course not very elegant…
Great to learn that, but in this case I want already the 2nd dotted half note to be released. I think this is provided only via the properties panel, right?
Untie-ing notes in order to change tremolo strokes is unnecessary, due to the relevant property described earlier, which can be set on individual notes in tie chains if you select them in Engrave mode.
@Lillie_Harris. Yes, I know I can use the property in Engrave. But I still find it much quicker to do this in Write. I find selecting just noteheads in Engrave to beliterally hit and miss!
It’s a common misconception with relatively new users that certain things can only be achieved by untie-ing notes, doing that thing, then retie-ing – such as adding dynamics mid-tie chain.
Therefore I’ll take any opportunity to reassure readers that this is not necessary, and there are other ways.
!