Hello, I’ve watched YouTube videos on adjusting audio events in the project window using the range selection tool and splitting the range. You can then grab the handle at the top of the new section and lower and raise the clip gain. This is helpful for evening out the dynamics of an audio recording. However, if I decide at a later date that I want to undo the split clips that I created from a previous session and start over (especially if I messed up and need to fix something), how can I remove the splits? Is that possible?
Hi,
You can either Glue them (you will get Audio Part) and then Bounce Selection (to get an Audio Event again).
Or you can just extend the Audio Event.