UR44 Line Output Question

I want to route the line outputs into a small mixer. Which outputs result in a stereo signal (1 + 2 or 1 + 3)?

Can I use a Y-cable for this?


1+2, and you just connect them with balanced cables. I dont know what y-cable you would want to use, there are types that will work and many that won’t.

I was looking on amazon and found this cable

Do you think this one might work?

So the cable is stereo 6,35 mm to 2 x mono 6,35 mm, is your mixer input stereo 6,35 mm? Can you tell what mixer you have?
You cannot use the stereo plug out from the UR44 unless you use the headphones out, which you should normally not use as it is designed for headphones (surprise).

I would be very grateful if you could explain to me how I can connect the main mix from the UR44 to my mixer. I have this (small) mixer Behringer Xenyx 802.


As the xenyx 802 should have balanced TSR inputs, just get a couple of balanced cables (TSR). Like this:

Out 1 & 2 from UR44 to Line in 3/4 or 5/6 on the behringer.

Hi Strummer,
thank you for your support. I have already ordered the cables from Thomann. I can then complete my configuration. Many Thanks!

1 Like