Very large delay on overdub tracks

I have used Cubase for a long time, but I am no expert.

I recently bought the 15 upgrade and some things change. I have a Groove Agent track and I listen to it as I record a bass track from my UR22. When I play it back, the bass track is way behind the drums. Not like some number of samples late, but a whole beat late. So I cut the audio file and slide it over so that it will play in time better. Then I record a piano track again with the UR22. I am listening to the Groove Agent track and the ‘corrected’ bass track and I can tell I am playing the piano in time with those tracks, but when I play back all three tracks again the piano is very late. It doesn’t sound at all like how I played!

Help! I recorded many times before with Cubase but never had this problem.

How does your studio setup looks like? Do you have the right drivers for your card, and is the buffer setting set right?

Yes, this looks the same as what I have, when I open the tune I was working on the only difference is the Input Latency 10.000 ms Output Latency 20.000 ms sort of differences. Also those values are ‘grey’ instead of white, I think that is because there are already tracks recorded. I am using the same driver for my UR22mkII.

Theen you should use the ‘Yamaha Steinberg USB driver’!
Then lower your buffers to some 64 or 32 samples to get the latensy down; if your system can cope with that.
Your latency is too high to record overdubs.

Hmm, yes I remember choosing the Yamaha Steinberg USB driver and lowering the buffer down to 64 samples when I was recording the two tracks, just in case that was involved with the problem at the time. I don’t know why when I reopened the file yesterday the Studio Setup had changed to the “built-in ASIO driver” - that seems kind of strange. Anyway at the time I was recording those two tracks I had done just what you are suggesting, so maybe there is some way in which my changes were ‘rejected’ at that time and this is the symptom of the problem I am having which crept in after I did the upgrade to Cubase 15. I can try going back to Cubase 14 and see if the problem goes away.

I don’t know why when I reopened the file yesterday the Studio Setup had changed to the “built-in ASIO driver”

Maybe the UR wasn’t turned on?

You should post screencaps of your settings - Another thing to try, turn on constrain delay compensation and see if it makes any difference.

Hmm, sometimes it is the right driver and sometimes it is not. The UR22 is on USB so anytime the laptop is switched on the interface is powered up. I am on a separate laptop right now so I can’t get the screen shot.

With the Yamaha Steinberg USB ASIO the input latency is 4.3ms and output latency is 5.3ms which seems pretty good. I’m not seeing the “constrain delay compensation” but I see Adjust for Record Latency is checked with Record Shift at 0 Samples, whatever that means. I think that even at Input Latency 10.000 ms Output Latency 20.000 ms, if that was the original settings, it wouldn’t have made the problem so bad. Let’s see, 60 sec in a minute at 164 bpm = that’s 370ms per beat, isn’t that right? Well at least I have some more ideas to check on in the future.

Oo oo, I see there is an update for Cubase15! Maybe that will help a little!

I’m not seeing the “constrain delay compensation”

It’s not in that dialogue …its the clock icon on the far left bottom transport bar