VST32 PlugIn GUI [solved]

Ok, have buy the update to new V9 version.
Biggest problem, I havn’t a GUI of my bridged VST32 PlugIns. Since years, I use the same effect chain in master section. There are 64Bit and (older) bridged 32Bit Plugins mixed. In 8.5 all ist ok, but in V9, all the bridged (jbridge) 32Bit Plugins haven’t a GUI … this is bad for me. Anyone has a solution?

Note: I was hope, that in V9 I can adjust the speaker volume with my hw controller, like in Nuendo (controlroom). Not these super mini rotary knob in the right corner … :frowning:

Note 2: I dosn’t found a command, to clear the master cain effect in one touch.

There is a left pointing arrow in the top right of the master section to reset it in one click. As you see in the picture, you can also assign a key command to clear it if you prefer.

Ah … thanx for this!!!

There are 64Bit and (older) bridged 32Bit Plugins mixed. In 8.5 all ist ok, but in V9, all the bridged (jbridge) 32Bit Plugins haven’t a GUI … this is bad for me. Anyone has a solution?

I don’t know. But did you install 9.0.10? Something affecting some plugins GUIs was fixed in this version.

Yes, 9.0.10 (build 536) - 64bit

Nobody have this issue except me?

Win10 Pro 64bit, WL9, jBridger and no GUI in bridged PlugIns?

If I’m the only one, then it’s a problem with my system …

Ok, have it. WaveLab exe need admin rights and all was fine again …