Wiederholungen und Sprünge

Dorico
1

Hallo,
ich habe in einem Lied folgenden Aufbau:

Takt 1-4 Vorspiel
Takt 5-12 Refrain
Takt 13-20 Strophe 1 und 3
Takt 21-28 Strophe 2 und 4
Takt 29-33 Coda

und möchte in Dorico Elements 5.1.51.2153 folgende Wiedergabe haben:

Vorspiel
Refrain
Strophe 1
Refrain
Strophe 2
Refrain
Strophe 3
Refrain
Strophe 4
Refrain
Coda

Ich habe es mit Wiederholungsenden und D.S. (mit zugelassenen Wiederholungen) probiert, aber dann springt die Wiedergabe nach Strophe 4 in Takt 1 und nicht in Takt 5. Die Coda konnte ich noch gar nicht funktionierend einbinden.
Kann ich diese Struktur in Dorico Elements überhaupt ermöglichen? Oder muss ich im schlimmsten Fall die entsprechenden Takte kopieren und einfügen, sodass ich ohne Wiederholungen und Sprünge alles von vorne bis hinten wiedergebe?
Vielen Dank für eure Rückmeldungen.

Viele Grüße
Matthias

Hello,
I have the following structure in a song:

Bar 1-4 prelude
Bar 5-12 chorus
bars 13-20 verse 1 and 3
Bar 21-28 Verse 2 and 4
Bar 29-33 Coda

and would like to have the following playback in Dorico Elements 5.1.51.2153:

Prelude
chorus
Verse 1
chorus
Verse 2
Refrain
Verse 3
chorus
Verse 4
chorus
Coda

I have tried it with repeat endings and D.S. (with authorised repeats), but then the playback jumps to bar 1 after verse 4 and not to bar 5. I have not yet been able to integrate the coda in a functioning way.
Can I enable this structure in Dorico Elements at all? Or, in the worst case, do I have to copy and paste the corresponding bars so that I can play everything from beginning to end without repetitions and jumps?
Many thanks for your feedback.

Best regards
Matthias

2

Start with this structure:

Image1
Image1861×122 9.2 KB

In engrave mode, select the fifth ending bracket and set the Y offset property to a large number to move the bracket off the page. In write mode, select the start of the fifth ending and turn it into a Coda:

Image2
Image2862×122 11.6 KB

Use staff text at the end of the Chorus to indicate the jump to the Coda after the last Verse.

2 Likes
3

Thank you for your quick reply. Unfortunately, I am not able to implement your suggested structure. How can I make the repeat bracket only play the first and second time or the second and fourth time? Maybe I don’t see the setting for this, but in Elements I don’t have anything like this in the properties for the bracket. Is this only possible in the Pro version? Or am I looking in the wrong place?

4

Isn’t there a German Dorico forum?

You will get a lot more understanding there.

5

In engrave mode, select the first repeat bracket. In the properties panel, set No. times played to 5 and Times played for segment to 1,3:

Image
Image1071×408 53.6 KB

1 Like
6

Great! That’s the solution. I hadn’t switched the engrave mode and was still in write mode, so I didn’t see the properties. Thank you very much!

1 Like