WL 8.5 Multi outputs?

WaveLab
1

Is it possible to send the output of a stereo track in Wavelab 8.5 to more than one per of ST output?
Using send to bus?

2

If you mean send to other outputs of your multichannel interface, yes, but it’s a little convoluted:

You can either:

  1. Duplicate your track, switch the Montage from “Stereo” to “Multichannel, free config” (in the lower right), click the “1:2” to the left of each of the tracks, and route the tracks separately from there, Track 1 to 1 & 2 and Track 2 to 3 & 4.

Or:

  1. Don’t duplicate the track. Switch the Montage from “Stereo” to “Multichannel, DVD Audio”, checkbox “Enable additional DVD Audio”, on Channels pulldown set “4 channel - Lf, Rf, C, LFE”. Then click to the left of the track where it says “Lf:Rf”. Set Top Audio to “Lf” and “Center”. Set Bottom Audio to “Rf” and “LFE”. It’s a strange setup, but it works, sending to 1 & 2 and 3 & 4.

This all assumes your interface in Options/VST Audio Connections is set from channel 1 to 8 from top to bottom. The montage track(s) will output to 1 & 2 and 3 & 4 of your interface.

Maybe someone else knows a better way.