I have several Locate Markers and Cycle Markers on a project. I have no problem switching between them. However, when I switch between the Cycle Markers, the activation ruler does not automatically follow to the currently selected marker. This, to me, is a major design flaw. But that point is for a …

I stand corrected. There are now 2 ways to activate the CM. I just double clicked on the CM itself and the Activation Ruler lit up. Unfortunately, both of these methods require the cursor, not to mention the already annoying “after the fact” status. I don’t understand why the key command doesn’t wo…

Thanks for your reply. I’m not using the Keyboard for locating CMs. I’m using a Nuage controller. I turned off the number lock, as you suggested, but it didn’t make any difference. Whenever I shift to a new CM it remains gray until I double click on it. Then it turns purple and is activated. It’s …

Cycle Marker KC Issue

Nuendo

ggmanestraki July 21, 2021, 4:10pm 3

Because, in Windows, when NumLock is on, pressing shift will temporary deactivate it. So you can’t really use the Shift+NumX keycommand to “Recall Cycle Marker X”. Deactivate NumLock and it works fine.