I see you have setup a midi remote using the Komplete Kontrol-1 midi port. It’s possible that it consumes your keyboard’s actions. At the same time, make sure that your instrument tracks are set to listen to ALL MIDI.
1 Like
My instruments are set to All midi…
The important part is the one about the midi remote.
Oh… strange… it was worked before… I don’t change anything… And when I play to my keys it shows that signal is go to Cubase but not sound and no visual representation that I play on keyboard on VST…
Sure. The thing is that the midi remote most probably consumes them. I’m not near a KK at the moment, but I can check later today whether this is the real cause.
Worked! You are right! For some resons it goes to my Nakedboard! Thanks!
1 Like
Ahhh the same problem here which started not with my Komplete M32 keyboard but the cord pads giving no sound unless added to a chord track and then triggered by the mouse. My keys on the keyboard triggered the sounds in Cubase the right way. Because almost all the lights on my Komplete M32 keyboard were off, I looked up the software that came with the keyboard (Komplete control etc) and I installed that. Since than I can use the transport keys and the knobs but the keys stopped making sounds. Cubase sees data coming from the keys in the bottom right corner, even the cord pads sees the keys coming in, but than signs of life are down. The chord pads still don’t give sounds. I made a ticket on the Steinberg website. I will take your advices the coming days and will report if anything has changed. Regards Gerrit from the Netherlands