When working with pitch bend, it’s often difficult to hit 0 by hand as the parameter has a range of 16000 units.
Have a key modifier like ALT snap the dragged point to zero would be a good workflow improvement.
When working with pitch bend, it’s often difficult to hit 0 by hand as the parameter has a range of 16000 units.
Have a key modifier like ALT snap the dragged point to zero would be a good workflow improvement.
+1
+10
+100
My work around is to use the info-line area at the top, if you ctrl click the value, it sets to zero…
But of course this is still a little slow as you have to move to the top of the screen…
this is how i also do it atm, but as you said, it’s quite slow.
+1
+1