WaveLab 13 (macOS): Plugin GUI displays are ahead of audio playback

Hi,

I’m experiencing an issue in WaveLab 13 on macOS where the visual displays of plugins appear to be several hundred milliseconds ahead of the actual audio playback.

This happens with all plugins I’ve tested, regardless of the manufacturer.

To clarify, the audio itself seems to play normally. Rather than experiencing noticeable audio latency, it feels as though the plugin meters and visualizations are updating too early compared to what I’m hearing.

My setup:

● DAW: WaveLab 13

● OS: macOS 26.7.2

● Audio interface: Steinberg UR242

● Audio buffer size: 256 samples

I found a similar issue reported in an older WaveLab discussion:

However, I’m not sure whether this is the same issue or whether it has been addressed in newer versions.

Is this a known issue in WaveLab 13? Is there any setting or workaround that can synchronize the plugin GUI displays with the actual audio output?

Any suggestions would be greatly appreciated.

Thanks!

Are you speaking about the metas inside plugins? Does it happen with the standback plugins?
BTW, 256 buffer size is a bit small. I recommend at least 512.

Yes, I’m referring to the meters and visualizations inside plugins, and the issue occurs with both Steinberg’s built-in plugins and third-party plugins.

I’ve also increased the buffer size to 512 samples, as recommended.

I’ve attached a screenshot showing the issue with Steinberg’s own MasterRig plugin.

As you can see, the playback cursor is still in a silent section of the audio montage (around 36:59.0), but MasterRig’s spectrum analyzer is already displaying the waveform of the upcoming audio.

In other words, the plugin’s visualizations appear to be running ahead of the actual playback position by several hundred milliseconds.

This is not limited to spectrum analyzers. I’ve observed similar behavior with other plugin meters, waveform displays, and bypass automation.

More importantly, the timing discrepancy also affects manual adjustments. For example, when I change an EQ parameter during playback, the GUI responds immediately, but the audible change occurs noticeably later. This makes it difficult to fine-tune parameters by ear in real time.

Audio playback itself seems normal, without glitches or dropouts.

Is this expected behavior in WaveLab, or could there be an issue with how plugin GUI updates and audio playback are synchronized?

Thanks for your help!

I can observe a little bit of latency as you explained, but not as much as you.
For example in the MasterRig itself, I see a difference between the spectrum view and the level meter. The spectrum view is in sync, but not the level meters

When you use plugins that have a high latency, then any change you do in the UI or the plugin. is delayed by that latency.

When will be able to see the exact number of samples of latency? Will this be in the next version of Wavelab?